Windows Nt 4.0X Network; Introduction; Preliminary Steps - Xerox DocuPrint C55 Supplementary Manual

Windows NT 4.0 Network

Introduction

Preliminary Steps

Your printer can be installed on a Windows NT network using one of
three methods:
TCP/IP protocol
DLC/LLC protocol
AppleTalk protocol
The Preliminary Steps given below must be accomplished for all
printers regardless of the protocol that is being used. Then, the Quick
Install Steps will detail the installation based on the protocol used on
your network.
1. Install the Network Interface Card in the printer (if not already
installed). Details are in this document in the section entitled
Installation of the Network Interface Card.
2. Connect appropriate cabling from printer to network. Details are
in this document in the section entitled Network Cable
Connection.
3. Print the Print Settings page. Details are in this document in the
section entitled Print The Print Settings Page. Retain this page
for reference.
4. Check the Print Settings page and verify that both the desired
protocol and connector are enabled.
5. Proceed to the Quick Install Steps for your network protocol.
W I N D O W S 24