Xerox 721 Message Manual page 82

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-6
OS0845 Exiting Lockout mode
The lockout diagnostic mode has been terminated.
Action None.
OS0850 Print Quality Adjustment pending
This message is displayed after you have entered a valid PQA
command and usually accompanies other related messages.
Action Enter the CONTINUE command, or press the <CON> key to
initiate PQA.
OS0851 Paper tray: x Output tray: n
This message identifies the paper and output tray numbers
involved in the current PQA operation and may accompany other
related messages.
Action None.
OS0852 Cluster: xxxxx Output tray: n
This message identifies the cluster name and output tray number
involved in the current PQA operation and may accompany other
related messages.
Action None.
OS0853 Mode: xxx housing, -plex
During PQA, this message identifies the housings being adjusted
and whether simplex or duplex printing is specified for the
current PQA operation. This message may accompany other
related messages.
Action None.
OS0854 After Print Quality
Adjustment: continue printing
automatically
This message specifies that when print quality adjustment is
completed, printing of the job will continue automatically.
Action None.
OS0855 After Print Quality
Adjustment: stop before
printing
This message specifies that when print quality adjustment is
completed, printing will not continue automatically.
Action None.
OS0856 Print Quality Adjustment request has been canceled
Your PQA CANCEL command request has been processed and
print quality adjustment has been canceled.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE