Xerox 721 Message Manual page 157

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
OS6360 Incorrect page sequence detected. Pages will be purged.
The system has detected a possible problem with the sequence
in which pages are being printed. All pages in progress will be
purged and the system will attempt to restart the job at the last
known good page.
Action None.
OS6450 Print file problem due to graphics.
The page log entry with the graphics specified will not fit in the
page log sector on the system disk. The job will abort.
Action Recreate the job, reducing the amount of graphic data.
OS6500 Cannot validate first data record; space to next report.
The tape record or block does not conform to the description in
JSL.
Action 1. Enter the SPACE 1 REPORTS command to go to the next
report. Recreate the lost report.
2. Rerun the lost report.
IF THIS MESSAGE APPEARS WITH "LABEL ERROR" MESSAGE:
Continue pressing the <CON> key until the job prints. (See
recommended actions for messages OS6010-OS6090.)
OS6510 Barcode reader not found.
A job is running using a JDL which specifies BARCODE or RBAR
commands and the barcode reader is either not installed or not
enabled.
Action Contact your systems specialist or Xerox Customer Service.
OS6520 Cannot read index page data block.
The system cannot read the index page data block due to a
hardware malfunction on the system disk.
Action Contact your systems specialist or Xerox Customer Service.
OS6550 Data not formatted as specified; space to next report.
JSL does not correctly describe the record or block format.
Action 1. Enter the SPACE 1 REPORTS command to go to the next
report.
or
Enter the ABORT job# command to cancel the job.
2. Recode the JDL statements. (Refer to the online and offline
chapters in your 4635 LPS Operator Guide.)
3. Restart the job.
OS6551 Problem found in block number nn.
A problem was found while reading block number nn from the
input data stream.
Action None
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-81