Xerox 721 Message Manual page 124

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-48
OS2260 Paper in selected tray too large. Change if desired.
The paper length guide in the selected tray is set for paper of a
larger size than that set at mini-sysgen. Printing stops. (This
message is followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action Enter CONTINUE O command, press the Continue button, or
press the <CON> key to resume printing. All subsequent
paper size mismatches are then ignored for the rest of the job.
or
1. Adjust the length guide and load paper of correct size.
(Refer to the chapter on feeder trays in your 4635 LPS
Operator Guide.)
2. Enter the CONTINUE O command, press the Continue
button, or press the <CON> key to resume printing.
or
1. Enter the ABORT O command to cancel the job.
2. Perform mini-sysgen, if authorized to do so, to change
default paper size. (Refer to 4635 LPS System Generation
Guide.)
3. Restart the job.
OS2261 Paper in selected tray too small. Change paper.
The paper length guide in the selected tray is set for paper of a
smaller size than that specified at mini-sysgen. Printing stops.
(Message is followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action 1. Adjust the length guide and load paper of correct size.
(Refer to the chapter on feeder trays in your 4635 LPS
Operator Guide.)
2. Enter the CONTINUE O command, press the Continue
button, or press the <CON> key to resume printing.
or
1. Enter the ABORT O command to cancel the job.
2. Perform mini-sysgen to reset paper size. (Refer to the
chapter on feeder trays in your 4635 LPS Operator Guide.)
3. Restart the job.
OS2262 Paper in cluster xxxx is too large
The specified cluster contains paper that is larger than that
specified by the print job
Action Change the paper in the specified cluster.
or
Change the FEED command.
or
Press the <CON> key to print on the larger paper.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE