Xerox 721 Message Manual page 55

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
IF2714 Syntax error: invalid character x has been encountered
The command line contains a character that is not allowed.
Action Reenter the command, using allowable characters.
IF2715 Syntax error: invalid command x has been encountered
The command requested is not allowed.
Action 1. Verify and reenter the command.
2. If the message reappears, contact your systems specialist or
Xerox Customer Support.
IF2720 Syntax error in statement x
An error exists in the given statement.
Action Check and reenter the command, using the corrected statement.
IF2730 Semantic error in statement x
An error exists in the meaning of the statement as formatted.
Action Check and reenter the command, using the corrected statement.
IF2790 Parser error: next _ charcalled with invalid mode
An error has occurred while the system was reading the
command line. This could be the result of a previous syntax
error in the command line.
Action Check the command syntax and retry.
IF2791 Parser error: invalid next _ char (2) call
An error has occurred while the system was reading the
command line. This could be the result of a previous syntax
error in the command line.
Action Check the command syntax and retry.
IF2805 Invalid medium parameter
The statement that defines the source (TAPE, CASSETTE, DISK,
FLOPPY) of the FIS master is incorrect.
Action Check and reenter the command using an allowable type of
medium.
IF2850 Invalid LPS seed parameter
The statement defining the LPS seed name (the base or root of
the name) of the newly created font file is incorrect.
Action 1. Verify the seed name in the LPS seed name parameter in the
font profile, and reenter the command.
2. If the message reappears, contact your systems specialist or
Xerox Customer Support.
IFU (INTERPRESS FONT UTILITY) MESSAGES
5-17