Xerox 721 Message Manual page 136

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-60
OS2737 Command not supported in this configuration.
The attempted command is not valid with this configuration.
Action Check and retry.
OS2740 JDE not found. Check and retry.
The JDE entered in the START command does not exist on the
system disk.
Action Reenter the START command with the correct JDE. (Refer to the
online chapter in your 4635 LPS Operator Guide.)
OS2741 JDL not found. Check and retry.
The JDL entered in the START command does not exist on the
system disk.
Action Reenter the START command with the correct JDL. (Refer to the
online chapter in your 4635 LPS Operator Guide.)
OS2745 Enter password for document.
"DocumentPassword" The correct password must be entered
before the job can be continued.
Action Key in the correct password.
OS2750 Job not found. Check and retry.
The job id number entered in the START command was not sent.
Action 1. Verify that the job number was entered correctly.
2. Reenter the START command.
3. If the message reappears, resend the job.
OS2760 Sample file not found. Check and reenter.
The SAMPLE command was entered, but the file name requested
for sampling is not in the system.
Action 1. Verify the file name and reenter the SAMPLE command
correctly.
2. If the message reappears, load the desired file to the system
disk. (Refer to your 4635 LPS Operations Reference chapter
on managing LPS resources for additional information.)
OS2800 Move or space function complete.
The system has completed spacing over information on magnetic
tape as requested.
Action Enter the CONTINUE I command if the place where input is
resuming has the same JDE and JDL as before SPACE command
was entered.
or
If JDE/JDL are different than before the spacing function, enter
the CONTINUE command followed by a new JDE and JDL ID
(CON "jde," "jdl"). (Refer to the offline chapter in your 4635
LPS Operator Guide.)
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE