Hip (Host Interface Processor) Messages - Xerox 721 Message Manual

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
4.
These messages may appear on your system controller display if
printer communications have been established through the host
interface processor (HIP). The HIP chapters in your 4635 LPS
Operator Guide and 4635 LPS Operations Reference provide
detailed information on HIP.
HP0010 Host interface processor unloaded
The HIP command was entered. HIP task is activated and ready
to receive jobs.
Action None.
HP0020 Host interface processor unloaded
The HIP END command was entered. HIP task is deactivated.
Action Wait for the system to print any files stored in the HIP buffer.
HP0030 Logging enabled
You have entered the HIP LOG [START] command. The system
has enabled the logging of selected XNS operations.
Action None.
HP0031 Logging disabled
You have entered the HIP LOG [STOP] command. The system is
telling you that it has disabled the logging of selected XNS
operations. You can disable selected XNS operations for the
purpose of record capturing.
Action None.
HP0080 Concatenated job operator display mode is 'ON'
In response to an operator command, HIP will display internal
job status while in a concatenated job mode.
Action None.
HP0085 Concatenated job operator display mode is 'OFF'
In response to an operator command, HIP will not display
internal job status while in a concatenated job mode.
Action None.
HIP (host interface processor)
messages
4-1