Xerox 721 Message Manual page 137

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
OS2810 Start-up message from Job Tape follows:
This message appears in a single report mode. A report delimiter
or forms information message will be displayed next.
Action Watch the printer control console display for a forthcoming
information message.
OS2811 The following is a document-generated "jobstart" message:
This is an informational message displayed prior to printing the
job. The actual "jobstart" message will follow.
Action None.
OS2812 The following is a document-generated "jobend" message:
This is an informational message displayed after the job has been
printed. The actual "jobEnd" message will follow.
Action None.
OS2820 Task not allowed till system status = 'Idle'
The system must be offline and not printing to process the
requested task. The message also appears if the REWIND
command is entered or the Rewind button is pressed while a
tape job is printing.
Action 1. Wait until the tape job completes before rewinding the tape.
or
Complete or abort any current jobs.
2. Enter the OFFLINE command.
3. Enter the desired command.
OS2822 Do a reset before retrying operation.
Your desired operation cannot be processed until the system has
been reset.
Action 1. Select Reset or enter the RESET command.
2. Retry the applicable operation.
OS2825 Complete Online Jobs. Then vary system offline.
A task was requested for which the system must be offline.
Action 1. Enter the CONTINUE command or press the <CON> key to
process remaining jobs.
or
Enter the RESET command to delete all jobs.
2. Enter the OFFLINE command.
OS2830 Enter 'HIP END' before starting another job.
HIP must be prohibited from automatically starting another job
while a job is being processed from another source.
Action Wait until system is idle, then retry.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-61