Xerox 721 Message Manual page 131

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
OS2650 Status file nearly full. Execute status file save procedure.
Enter SFS clear after file save.
Very little space remains in the status file memory. When new
data is stored, the oldest report data could be lost.
Action 1. Write the current status file to magnetic tape. (Refer to your
4635 LPS Operations Reference chapter on tracking system
activity for additional information.)
2. Enter the SFS CLEAR command, then the SFS CREATE
command to create a new Status File.
OS2660 Do you want to enter Accounting? [Y or N]
or
Do you want to enter Accounting? Type Y for 2000
reports or N for 100 reports.
(This message appears at the end of the sysgen process.) To set
the size of the status file:
Action Enter Y to create an accounting file for 2000 reports.
or
Enter N to create an accounting file for 100 reports. (Refer to
your 4635 LPS System Generation Guide .)
0S2669 Enter 'PQA Start' to initiate a Print Quality Adjustment.
Print Quality Adjustment (PQA) is not pending. Therefore, enter
the PQA START command to start the PQA process.
Action None.
OS2670 Enter PQA or SUB INK Command or Abort Report or Print
Job.
The color housing is not ready. This message is displayed when
the system requires a print quality adjustment (PQA).
Action Enter the PQA command to initiate print quality adjustment
or
Substitute an ink via the SUBSTITUTE INK command
or
Abort the job.
OS2671 Enter 'PQA CANCEL' to cancel Print Quality Adjustment.
This message is displayed when print quality adjustment is
pending.
Action Enter PQA CANCEL to stop print quality adjustment
or
Enter CONTINUE to initiate PQA.
OS2672 Enter PQA Command again.
Your PQA command was not completed successfully.
Action Reenter the PQA command again or take other actions specified
in the message.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-55