Xerox 721 Message Manual page 159

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
OS6660 Begin value is off the page.
The BEGIN statement in JDL specifies that print is to start at a
point located off the paper currently loaded in printer. The job
will abort.
Action Recode JSL so that paper dimensions (PAPERSIZE command)
agree with the BEGIN statement. (Refer to your 4635 LPS
PDL/DJDE Reference.)
OS6650 Input has recovered to next report in job.
Job recovery has been initiated after a software failure. After the
second attempt, the system is unable to recover data for the
current report. Input has moved to the next report boundary.
Offline reports are partially printed.
Action Restart the lost report.
OS6651 Output has recovered to next report in job.
Job recovery has been initiated after a software failure. After the
second attempt, the system is unable to recover data for current
report. The output has moved ahead and will print the next
report.
Action Restart the lost report.
OS6652 Output has recovered to next page boundary.
Job recovery has been initiated after a software failure. Output
attempted unsuccessfully to print a page on which data was lost.
Now output has moved ahead and will print the next page of the
report.
Action Restart the job if data loss is unacceptable.
OS6653 Successive page recovery stopped by end of report.
Job recovery was initiated after a software failure. Page-by-page
data recovery has reached the end of the report and stopped.
The report is aborted.
Action Restart the job.
OS6654 Set recovery cancelled until next set boundary.
An irrecoverable error has occurred on a specific page. Because
of this, the set of which the bad page is a member cannot be
recreated due to a jam condition. Page recovery will be in effect
until the next set boundary.
Action None.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-83