Xerox 721 Message Manual page 211

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
**File, xxxx, can not be scaled (unknown error)**
The requested file cannot be scaled due to an unknown error.
Action Contact your systems specialist or Xerox Customer Support.
**Font file xxxx cannot be scaled (byte escapement)**
The requested font file cannot be scaled due to a problem with
byte escapement.
Action 1. If you are not using an Interpress font, add switch "A" (assign
escapement) to the SCALE command line. (Refer to your
4635 LPS OSS Program Description, -11.)
2. If the message reappears, contact your systems specialist or
Xerox Customer Support.
**Font file, xxxx, cannot be scaled (extended metrics)**
The requested font file cannot be scaled due to a problem with
extended metrics.
Action 1. Use the IFU ADD command to get the correct point size.
(Refer to your 4635 LPS Operations Reference chapter on
HIP-accessed communicating modes for additional
information.)
2. If the message reappears, contact your systems specialist or
Xerox Customer Support.
**Font file, xxxx, cannot be scaled (graphic font)**
The requested font file cannot be scaled because the resulting
file would not be compatible with the original.
Action None.
**Font index in TL does not match font list.
The font index in the text line does not match the font list. The
FRM file is probably corrupted or created incorrectly.
Action 1. Recreate the FRM file using FDL and retry the SCALE
command.
2. If the message reappears, contact your systems specialist or
Xerox Customer Support.
**Font scaling resulted in size mismatch**
Scaling caused a mismatch between the estimated and actual
bitmap sizes.
Action Contact your systems specialist or Xerox Customer Support.
**Font xxxx is not alpha-numeric**
The font or logo is either Kanji or corrupted.
Action 1. Check the file via the SAMPLE command.
2. If corrupted, restore the font from a backup source.
SCALE COMMAND MESSAGES
11-3