Xerox 721 Message Manual page 145

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
OS3013 Paper Tray 4 fault -- see message at printer.
Feeder tray 4 has not risen completely or a paper jam has
occurred at the area indicated on the printer control console
display.
Action 1. Press the i button on the printer control console for further
console messages if the control console display instructs you
to do so.
2. Clear the jam in area indicated if the display instructs you to
do so.
3. Ensure that the length guide is against the paper edge.
(Refer to the chapter on feeder trays in your 4635 LPS
Operator Guide.)
4. Pull out feed tray 4, then push it all the way back in. The
feed tray should rise automatically.
5. If the feeder tray does not rise, enter the FEED command to
switch to another feed tray to complete the job.
6. If the problem continues, contact your systems specialist or
Xerox Customer Service.
OS3020 Finisher fault--see printer message.
A problem has occurred in the finishing option of the printer.
Action Refer to the printer control console display messages for
instructions.
OS3025 If fault continues enter 'SEL TRAY' or 'ABORT O' or
A fault in the collection area of the stitcher/stacker has occurred
(followed by message OS2000 PRESS CONTINUE TO RESUME
PRINTING).
Action Press the <CON> key to resume printing, ignoring the fault.
or
Enter the SELECT TRAY command to redirect the output to the
sample tray.
or
Abort the current report with the ABORT O command.
OS3026 If fault continues, enter 'STITCH OFF'
A stitcher fault has occurred.
Action 1. Press the <CON> key to ignore the first occurrence of the
fault.
2. If the fault continues, enter the STITCH OFF command to
turn off the stitching option.
3. Contact your systems specialist or Xerox Customer Service.
OS3040 Output offset failure. Set will not be offset
A stitcher/stacker offset failure has occurred.
Action Check output for proper job separation (two jobs may have been
combined).
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-69