Xerox 721 Message Manual page 144

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-68
OS3009 Remove top sheet in compiler tray. See printer message.
There is an extra sheet in the collection area of the
stitcher/stacker. Follow the instructions on the printer display.
Action 1. Raise the stitcher/stacker lid and remove the extra sheet from
the collection area.
2. Press the <CON> key to resume printing.
OS3010 Printer is warming up.
The printer is unable to respond to the entered command
because the fuser has cooled to below operating temperature.
Action 1. Wait for the fuser to reheat (the warmup light on the system
controller turns off).
2. Reenter the command.
A command was entered while the printer was in the power-
saver state or had just been powered on.
The printer control console displays one of the following:
BOTH TRAYS SET FOR _._X_._" PAPER
BOTH TRAYS SET FOR _X_MM PAPER
PRINTER IS WARMING UP
PRINTER IS WARMING UP. CHECK PAPER SUPPLY IN TRAY 1
PRINTER IS WARMING UP. CHECK PAPER SUPPLY IN TRAY 2.
PRINTER IS WARMING UP. PRESS i
PRINTER IS WARMING UP. OUTPUT TRAY 1 IS FULL
PRINTER IS WARMING UP. OUTPUT TRAY 2 IS FULL.
PRINTER IS WARMING UP. PAPER TRAY 1 IS EMPTY. PRESS i
PRINTER IS WARMING UP. PAPER TRAY 2 IS EMPTY. PRESS i
TRAY 1 IS SET FOR _._X_._" PAPER. TRAY 2 IS SET FOR
_._X_._" PAPER.
TRAY 1 IS SET FOR _X_MM PAPER. TRAY 2 IS SET FOR
_X_MM PAPER.
WARMING UP. BOTH PAPER TRAYS NOT SET FOR SAME SIZE.
PRESS i
1. Wait until READY TO PRINT appears on the printer control
console display.
OS3012 Paper Tray 3 fault -- see message at printer.
Feed tray 3 has not risen completely or a paper jam has occurred
at the area indicated on the printer control console display.
Action 1. Press the i button on the printer control console for further
console messages if the control console display instructs you
to do so.
2. Clear the jam in the area indicated if the display instructs you
to do so.
3. Ensure that the length guide is against the paper edge.
(Refer to the chapter on feeder trays in your 4635 LPS
operator guide.)
4. Pull out feed tray 3, then push it all the way back in. The
feed tray should rise automatically.
5. If the feed tray does not rise, enter the FEED command to
switch to another feeder tray to complete the job.
6. If the problem continues, contact your systems specialist or
Xerox Customer Service.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE