Os Level 4: System Or Tape Problem - Xerox 721 Message Manual

OS Level 4: System or tape problem

XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
OS3705 Suspected set delivery error.
There is an apparent set delivery problem.
Action Visually inspect the sets.
OS3710 Set integrity problem. Partial set ejected.
The integrity of the current set in the stitcher/stacker's collection
area is questionable; i.e., a page has been skipped.
Action 1. Check the output.
2. Press the <CON> key to resume printing.
The message may also appear when a printer fault occurs or if
the printer is powered off.
States a problem and explains what action(s) to take.
OS4010 Cannot find end of tape reflector strip. 'CONTINUE I'
The system did not encounter the End of Tape (EOT) label.
Action 1. Enter the ABORT I command to cancel the job.
2. Clean the magnetic tape drive to ensure read was accurate.
(Refer to the maintenance chapter in your 4635 LPS Operator
Guide.)
3. Restart the job. If the message reappears, do one of the
following:
a. Enter the CONTINUE I command to resume processing.
If any "Label Error" messages appear, continue pressing
the <CON> key until the job prints.
Note: Check output for pages formatted incorrectly. You may
wish to recreate the job.
or
Enter the ABORT I command to cancel the job.
b. Check JSL and make any changes necessary. (Refer to
your 4635 LPS Operations Reference chapter on job
control.
c. If there are no JSL errors, enter the START n, DUMP
command to obtain a tape dump for analysis.
d. Recreate the job, ensuring tape labels are correct. (Refer
to your 4635 LPS Tape Formats Manual.)
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-71