Xerox 721 Message Manual page 210

SCALE COMMAND MESSAGES
11-2
**EDIM META-Code not supported**
The extended dimension (EDIM) function cannot be scaled to
600 spi.
Action None.
Enter Input file name or <RETURN> to exit.
An input file name must be included in the command to invoke
SCALE.
Action Enter the input file name
or
Press the <RETURN> key to exit this activity.
**Error (n.n) generating Output File**
The system is unable to generate the output file.
Action 1. Check the SCALE command and reenter.
2. If the message reappears, contact your systems specialist or
Xerox Customer Support.
**Error (n.n) reading Input File**
There is a problem reading the input file. This is a disk error,
e.g., a bad block.
Action 1. RNAME input file to a well-known name (e.g., BADnnn.TMP).
2. Restore the file from a backup source (e.g., tape, floppy, or
host).
3. Recreate the file using FDL if an FRM file.
4. Contact your systems specialist or Xerox Customer Service to
log the bad sector and delete the well-known name.
File already exists, overwrite xxxx (Yes or No)?
The requested file already exists.
Action If you want to overwrite the existing file, enter YES.
or
Enter NO if you do not.
**File type for output name must be xxxx or yyyy**
The file type for the output name must be as listed in the
message.
Action Reenter the SCALE command using the correct file type in the
output name. (Refer to your 4635 LPS Operations Reference
chapter on managing LPS resources for additional information.)
**File type in output name must be xxxx
The file type in the output name must be from an acceptable
font directory.
Action Reenter the output name using a font from the specified
directory. Acceptable file types are FNT, FN6, FR6, LG0, and LG6.
(Refer to your 4635 LPS Operations Reference chapter on
managing LPS resources for additional information.)
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE