Xerox 721 Message Manual page 36

HIP (HOST INTERFACE PROCESSOR) MESSAGES
4-14
HP5000 Host restarted. Trying to reestablish communications
The link to the DMR host was broken and is now reestablished.
HIP is attempting to reestablish communications with the host
and resume from the point where the link was broken.
Action None.
HP7100 Can not change hosts while jobs are pending or active
Hosts cannot be changed until all jobs are completed.
Action 1. Wait until active and pending jobs have been printed.
2. Enter the appropriate HIPHOST command to change hosts.
HP8100 HIP dynamic memory allocation failure: reload
HIP does not have enough memory to continue.
Action 1. Enter the HIP END command.
2. Restart HIP or reboot the system.
HP8250 Fatal protocol violation detected
Commands used violate the higher-level software protocols used
to communicate between the 4635 LPS and the host. The host
will be advised to restart communication with the printer. No
data should be lost in this process.
Action None.
HP9200 Interface failure: unable to receive data
A hardware error has occurred. The system is unable to recover
lost data. The job will abort and the interface will go offline.
Action 1. Resend the job.
2. If the error continues, contact your systems specialist or
Xerox Customer Service.
HP9210 Interface failure: failed to go offline
HIP is unable to post the offline status to the XPAF host
computer.
Action None.
HP9400 HostCLR not received. See host for reason
The HIP DIAGNOSTIC command for interactive diagnostics was
entered. The system failed Test 1: HOSTCLR control line not
verified.
Action 1. Wait until the diagnostic test is terminated or completed.
2. Contact your systems specialist or Xerox Customer Service
and give information appearing on the 871-CM display.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE