Xerox 721 Message Manual page 126

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-50
OS2290 Enter 'RETURN' to continue cluster display
The cluster list contains more than a single display of information.
Action Press the <ENTER> or <RETURN> key to view additional
displays.
OS2291 Response timeout - cluster display stopped
The CLUSTER or CLP command was used to display the cluster
list but the <ENTER> key was not pressed within a reasonable
amount of time to continue the cluster display. The cluster
display has been terminated.
Action Reenter the CLUSTER or CLP command, if desired.
OS2295 Problem with stockset, see display below
One or more clusters in the current stockset has a problem. A
cluster display follows, indicating specific errors that should be
resolved before printing. If a status is flashing, it must be
resolved before you can print.
Action 1. Correct the problem shown flashing in the status column.
2. Press the <CON> key to resume printing.
OS2296 Log printing not allowed until system status='Idle'
The system must be offline and not printing to process a log
print request.
Action Complete or abort any current jobs, enter the OFFLINE command
and then resubmit the log print request.
OS2310 Bin x not ready
For a system with one or two output tray(s), the selected output
tray is not ready to begin processing print jobs.
This message may be displayed after you have entered
'CONTINUE O'. This message is followed by OS2000 ENTER
'CONTINUE O' TO RESUME PRINTING, if printing is ready to
begin.
Action None.
OS2320 Bin 2 not ready
The selected output tray must be ready in order for print quality
adjustment to start. If not, this message is displayed after you
have entered the CONTINUE O command. This message is
followed by OS2000 ENTER 'CONTINUE O' TO RESUME
PRINTING.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE