Channel Audio Kit Installation; Figure 4-19: Connect Power Cable To Power Supply - IEI Technology WAFER-ULT5 Manual

Hide thumbs Also See for WAFER-ULT5:

Table of Contents

WAFER-ULT5 SBC

Step 3:

Connect power cable to power supply. Connect one of the 4-pin (1x4) Molex

type power cable connectors to an AT power supply. See Figure 4-14.

Figure 4-14: Connect Power Cable to Power Supply

4.8.2 7.1 Channel Audio Kit Installation

NOTE:

This item must be ordered separately, and connects to the audio

connector. For further information please contact the nearest

distributor, reseller or vendor or contact an IEI sales representative

directly.

The audio kit attaches to the audio connector. The audio kit provides 7.1 channel audio.

To install the audio kit, please refer to the steps below:

Step 1:

Connect the cable to the audio kit. Connect the included cable to the audio kit.

Make sure pin 1 aligns with the marked pin.

Page 55

Table of Contents