Channel Audio Kit Installation; Figure 4-11: Connect Power Cable To Power Supply - IEI Technology WAFER-JL-N5105 User Manual

3.5" sbc with intel 10nm jasper lake celeron n5105 processor with dual displays, ddr4, triple intel 2.5 gbe, usb3.2, m.2, sata, com, soc, rohs

Hide thumbs Also See for WAFER-JL-N5105:

Table of Contents

WAFER-JL-N5105 SBC

4.6.2 7.1 Channel Audio Kit Installation

NOTE:

This item must be ordered separately, and connects to the audio

connector. For further information please contact the nearest distributor,

reseller or vendor or contact an IEI sales representative directly.

The audio kit attaches to the audio connector. The audio kit provides 7.1 channel audio.

To install the audio kit, please refer to the steps below:

Step 1:

Connect the cable to the audio kit. Connect the included cable to the audio

kit. Make sure pin 1 aligns with the marked pin.

Step 2:

Conect the cable to the board. Connect the other end of the cable to the

board. Make sure to line up the marked pin 1.

Page 55

Table of Contents

Wafer-jl-n5105-r10 167320