Internal Peripheral Device Connections; Audio Kit Installation; Figure 4-9: Audio Kit Cable Connection - IEI Technology WAFER-CV-D25501 Series User Manual

4.6 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the on-board connectors.

4.6.1 Audio Kit Installation

The Audio Kit that came with the WAFER-CV-D25501/N26001 connects to the 10-pin
audio connector on the WAFER-CV-D25501/N26001. The audio kit consists of three
audio jacks. One audio jack, Mic In, connects to a microphone. The remaining two audio
jacks, Line-In and Line-Out, connect to two speakers. To install the audio kit, please refer
to the steps below:
Step 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 2: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 4-9.

Figure 4-9: Audio Kit Cable Connection

Page 50
WAFER-CV-D25501/N26001 3.5" SBC