Table of Contents
Advertisement
Appendix | ASCII Communication with Controller
A 5.3.13 Selection of Measured Values to be Output
A 5.3.13.1 General
Setting the values to be output via the RS422 interface.
A limitation of the data volume via the RS422 depends on the measuring frequency and the baud rate.
In multi-layer measurement mode, any desired distances and differences can be selected for output.
A 5.3.13.2 Data Selection for RS422
OUT_RS422
Describes which data is output via this interface.
A 5.3.13.3 List of Possible Signals for RS422
META_OUT_RS422
List of possible data for the RS422.
Command is mapped in the SDO 0x31F5.
A 5.3.13.4 List of Selected Signals, Sequence via Rs422
GETOUTINFO_RS422
Returns the order of the signals via this interface.
Command is mapped in the SDO 0x31F5.
A 5.3.14 Switching Outputs
A 5.3.14.1 General
Commands are valid for the IFD2410/2415.
A 5.3.14.2 Error - Switching Outputs
ERROROUT1 [01ER1|01ER2|01ER12|ERRORLIMIT]
ERROROUT2 [01ER1|01ER2|01ER12|ERRORLIMIT]
Setting the error switching outputs.
- 01ER1: Switching output is switched in the event of an intensity error
- 01ER2: Switching output is switched in the event of a measuring range error
- 01ER12: Switching output is switched in the event of an intensity error or a measuring range error
- ERRORLIMIT: Switching output is switched when the measured value is outside the limit values; the basis is formed by
the settings for ERRORLIMITSIGNAL1/2, ERRORLIMITCOMPARETO1/2 and ERRORLIMITVALUES1/2.
A 5.3.14.3 List of Possible Signals for Error Output
META_ERRORLIMITSIGNAL1
META_ERRORLIMITSIGNAL2
List of all signals that are possible for the ERRORLIMITSIGNALn command.
A 5.3.14.4 Set Signal to be Evaluated
ERRORLIMITSIGNAL1 [<signal>]
ERRORLIMITSIGNAL1 [<signal>]
Selection of the signal to be used for the limit value analysis.
confocalDT 2410/2411/2415
Page 166
Advertisement
Table of Contents
Need help?
Do you have a question about the confocalDT IFD2410 Series and is the answer not in the manual?