A 5.3.12 Data Output; A 5.3.12.1 Digital Output Selection; A 5.3.12.2 Output Data Rate; A 5.3.12.3 Reduction Counter For Output Of Measured Values - MICRO-EPSILON confocalDT IFD2410 Series Operating Instructions Manual

Appendix | ASCII Communication with Controller

A 5.3.12 Data Output

A 5.3.12.1 Digital Output Selection

OUTPUT [NONE|([RS422 | IE] [ANALOG] [ERROROUT])]
- NONE: No output of measured values
- RS422: Output of measured values via RS422
- IE: Output of measured values via Industrial Ethernet, not parallel with RS422
- ANALOG: Output of measured values via analog output
- ERROROUT: Error or status information via the error outputs
Command starts the output of measured values. The connection to the measured value server can already exist or can
now be established.

A 5.3.12.2 Output Data Rate

OUTREDUCEDEVICE [NONE|([RS422] | [ANALOG])]
Reduction of output of measured values via specified interfaces.
- NONE: No reduction of output of measured values
- RS422: Reduction of output of measured values via RS422
- ANALOG: Reduction of output of measured values via analog interface

A 5.3.12.3 Reduction Counter for Output of measured values

OUTREDUCECOUNT <count>
Reduction counter for output of measured values.
Only each nth measured value is output. The other measured values are rejected.
- Number: 1...3000000 (1 means all frames)
Command is mapped in the SDO 0x31B3.

A 5.3.12.4 Error Handling

OUTHOLD NONE|INFINITE|<count>
Sets the measured value output behavior in the event of an error.
- NONE: Last measured value not held; error value output
- INFINITE: Last measured value held indefinitely
- Number: Holds the last measured value via measurement cycle count and then outputs the error value (maximum
1024)
Command is mapped in the SDO 0x31B2.
1) The controller issues an error if IE and RS422 are selected in parallel. IE is implicitly activated when the EtherCAT state machine
starts up or during PDO mapping; if RS422 was previously active, it is implicitly removed.
confocalDT 2410/2411/2415
1
.
Page 165