Using The Parameter Menu (M2); Finding The Parameter - Danfoss VACON NXP IP00 Operating Manual

VACON® NXP IP00 Drive Modules
Operating Guide

8.3 Using the Parameter Menu (M2)

8.3.1 Finding the Parameter

Use these instructions to find the parameter to edit.
Procedure
1.
To find the Parameter menu, scroll down in the main menu until the location indication M2 shows on the first line of the
display.

Parameters
2. Push the Menu button Right to move into the Parameter Group Menu (G#).

Input signals
3. To find the parameter group, use the Browser buttons Up and Down.

Input signals
4. Use the Browser buttons Up and Down to find the parameter (P#) to edit. To move directly from the last parameter of a
parameter group to the first parameter of that group, push the Browser button Up.

Min Frequency
86 | Danfoss A/S © 2023.09
READY
Keypad
G1 G8
READY
Keypad
G1 G8
READY
Keypad
P1 P18
READY
Keypad
13.95 Hz
Using the Control Panel
AQ351737303996en-000201 / DPD00888