Table of Contents
Advertisement
VACON® NXP IP00 Drive Modules
Operating Guide
3.
To change the parameter lock status, use the Browser buttons.
4.
To accept the change, push the [enter] button.
8.7.6.7 Start-up Wizard (P6.5.3)
The start-up wizard helps in the commissioning of the AC drive. By default, the start-up wizard is active.
In the start-up wizard, this information is set:
•
the language
•
the application
•
the values for a set of parameters that are same to all applications
•
the values for a set of application-specific parameters.
The table lists the functions of the keypad buttons in the start-up wizard.
Action
Accepting a value
Scrolling for options
Changing a value
8.7.6.8 Activating/Deactivating the Start-up Wizard
Use these instructions to activate or deactivate the Start-up Wizard function.
Procedure
1.
In the System menu (M6), find the page P6.5.3.
2.
To go to the edit mode, push the Menu button Right.
3.
Select the action:
-
To activate the start-up wizard, select Yes with the Browser buttons.
-
To deactivate the start-up wizard, select No with the Browser buttons.
4.
To accept the selection, push the [enter] button.
8.7.6.9 Enabling/Disabling the Change of Multimonitoring Items
Use Multimonitoring to monitor up to 3 actual values at the same time (see
Monitored values in the Application Manual of your application).
Use these instructions to enable the change when changing the values that are monitored with other values.
Procedure
1.
In the Security submenu, find Multimonitoring items page (P6.5.4, Multimon. items) with the Browser buttons.
2.
To go to the edit mode, push the Menu button Right.
Change Enabled starts to blink.
3.
Use Browser buttons Up and Down to select Change Enabled or Change Disabled.
4.
Accept the selection with the [enter] button.
Danfoss A/S © 2023.09
Button
[enter] button
Browser buttons Up and Down
Browser buttons Up and Down
8.2 Using the Monitoring Menu (M1)
Using the Control Panel
and the chapter
AQ351737303996en-000201 / DPD00888 | 101
Advertisement
Table of Contents
