Johnson Controls tyco Power Pro Series Reference Manual page 209

[377] Communication Variables
(3-digit decimal)
Range: 000-255 attempts unless otherwise noted
Description on page 1
001 – Swinger Shutdown Attempts:
Default: 003
CP-01
Default: 002
002 – Communication Delays:
003 – Periodic Test Transmission Cycle (Default: 030 hours/days):
004 – Periodic Test Transmission Time of Day (Default: 9999):
011 – Maximum Dialing Attempts: (Default: 005):
012 – Delay Between PSTN Attempts: (Default: 003 seconds):
013 – Delay Between Force Attempts: (Default: 020 seconds):
014 – Post Dial Wait for Handshake: (Range: 001-255; Default: 040 Seconds; UL=45):
015 – IP/Cellular Wait for Ack: (Range: 001-255; Default: 060 seconds):
016 – IP/Cellular Fault Check Timer: (Range: 003-255; Default: 010):
Communicator Option 1
[380]
Description on page 1
Section 6: Programming Worksheets
Alarms and Restore (000-014):
Tampers and Restore:
Maintenance and Restore:
Communication Zone Delay
Default: 000
CP-01
AC Failure Communication Delay
Default:030 minutes/Hours
TLM Trouble Delay
NA
EN
Wireless Zone Low Bat. Transmission Delay
Default: 0000 days/hours
Delinquency Transmission Cycle Delay
Default: 030 days/hours
Communications Cancel Window
Default: 000 minutes
CP-01
1 – R Communications Enabled
2 – o Restore on Bell Time-out
3 – o Pulse Dialing
4 – o Pulse Dial after 5th Attempt
5 – o Parallel Communications
NA
6 – o Alternate Dial
EN 6 – R Alternate Dial
7 – o Reduced Dialing Attempts
- 209 -
Default: 030
Default: 010 checks
Default:002 checks
Default: 005 minutes