Johnson Controls tyco Power Pro Series Reference Manual page 147

[432] Session 1 Integration Outgoing Port
Default (03070) Valid range: 00000- 65535
This section is used to program the outgoing port for integration via UDP.
[433]Session 1 Integration Incoming Port
Default (03071) Valid range: 00000- 65535
This section is used to program incoming port for integration via TCP.
[450]-[460] Repeats [423]-[433] for Session 2
[477]-[4873] Repeats [423]-[433] for Session 3
[504]-[514] Repeats [423]-[433] for Session 4
[691] - [694] Session 1 to 4 Notification Control
[1] - Alarm and Alarm Restore Notifications Off (ON)
[2] - Tamper and Tamper Restore Notifications Off (ON)
[3] - Arming/Disarming Notifications (ON)
[4] - Trouble and Trouble Restore Notifications (ON)
[5] -Test Transmission Notifications (ON)
[901] Receiver Test
This section is used to enable Ethernet or cellular ports for receiver diagnostic test transmissions.
[1] Receiver 1 Default (OFF)
[2] Receiver 2 Default (OFF)
[3] Receiver 3 Default (OFF)
[4] Receiver 4 Default (OFF)
System Information (Read Only)
Note: Provided for information (read-only). Values in these sections cannot be modified by the installer.
[976] - Radio Configuration File Version
[977] - Cellular Network Provider - MCC/MNC Code
[978] - Cellular Network Type
00 GPRS
01 EDGE
02 WCDMA
03 HSDPA
[979] - Cellular Network CSQ
[980] - Radio Reset Codes
[981] - Radio Type
[982] - Radio Firmware Version
[983] - Firmware Update Diagnostics Section
Firmware updates for panel and the communicator itself can be made from the communicator.
Section 5: Programming
2G 04 LTE
2G 05 LTE Advanced
3G 06 CDMA
CDMA 07 EVDO
- 147 -
Ethernet only
LTE
LTE ADVANCE
WCDMA