Johnson Controls tyco Power Pro Series Reference Manual page 2

Safety Instructions for Service Personnel
WARNING: When using equipment connected to the telephone network, always follow the basic safety instructions provided
with this product. Save these instructions for future reference. Inform the end-user of the safety precautions that must be
observed when operating this equipment.
Before Installing The Equipment
Ensure your package includes the following items:
Installation and User manuals, including the SAFETY INSTRUCTIONS.
l
READ and SAVE these instructions!
Follow all WARNINGS AND INSTRUCTIONS specified within this document and/or on the equipment.
HS3032/HS3128 alarm controller
l
Power Supply, direct plug-in
l
Selecting A Suitable Location For The Alarm Controller
Use the following list as a guide to find a suitable location to install this equipment:
Locate near a telephone socket and power outlet.
l
Select a location free from vibration and shock.
l
Place alarm controller on a flat, stable surface and follow the installation instructions.
l
Do NOT locate this product where people may walk on the secondary circuit cable(s).
Do NOT connect alarm controller to electrical the same circuit as large appliances.
Do NOT select a location that exposes your alarm controller to direct sunlight, excessive heat, moisture, vapors, chemicals or
dust.
Do NOT install this equipment near water. (e.g., bath tub, kitchen/laundry sink, wet basement, near a swimming pool).
Do NOT install this equipment and accessories in areas where risk of explosion exists.
Do NOT connect this equipment to electrical outlets controlled by wall switches or automatic timers.
AVOID interference sources.
AVOID installing equipment near heaters, air conditioners, ventilators, and refrigerators.
AVOID locating equipment close to or on top of large metal objects (e.g., wall studs).
See "Locating Detectors and Escape Plan" on page 282 for information on locating smoke and CO detectors.
SAFETY Precautions Required During Installation
NEVER install this equipment and/or telephone wiring during a lightning storm.
l
NEVER touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the net-
l
work interface.
Position cables so that accidents can not occur. Connected cables must NOT be subject to excessive mechanical
l
strain.
Use only the power supply provided with this equipment. Use of unauthorized power supplies may cause damage.
l
For direct plug-in versions, use the power supply module supplied with the device.
l
WARNING: THIS EQUIPMENT HAS NO MAINS ON/OFF SWITCH. THE PLUG OF THE POWER SUPPLY CORD IS INTENDED TO SERVE
AS THE DISCONNECTING DEVICE IF THE EQUIPMENT MUST BE QUICKLY DISCONNECTED. IT IS IMPERATIVE THAT ACCESS TO
THE MAINS PLUG AND ASSOCIATED MAINS SOCKET/OUTLET IS NEVER OBSTRUCTED.
IMPORTANT NOTE FOR INTERNATIONAL MARKET (EU, AUS, NZ)!
This equipment is stationary-fixed and must be installed by Skilled Persons only. Skilled Person is defined as a person with
relevant education or experience to enable him or her to identify hazards and to take appropriate actions to reduce the risks
of injury to themselves and others. It must be installed and used within an environment that provides the pollution degree
max 2, over voltages category II, in non-hazardous, indoor locations only. When using equipment connected to the mains
and/or to the telecommunication network, there are basic safety instructions that should always be followed. Refer to the
safety instructions provided with this product and save them for future reference. To reduce the risk of fire, electric shock
and/or injury, observe the following: Do not attempt to service this product yourself. Opening or removing the cover may
expose you to dangerous voltage or other risk. Refer servicing to qualified service persons. Never open the device yourself.
Use authorized accessories only with this equipment. DO NOT leave and/or deposit ANY object on the top of the cabinet of
this equipment! The cabinet as it is installed on the wall is not designed to support any supplementary weight! Do not spill
any liquids on the cabinet. Do not touch the equipment and its connected cables during an electrical storm; there may be a
- 2 -