Johnson Controls tyco Power Pro Series Reference Manual page 148

Table 5-8 Response Code Descriptions and Corresponding Actions
Response Code
Bad File
00
01
02
03
04
05
Panel is Busy
20
21
22
25
Firmware Update Sequence Change
A0
A1
A2
AA
AB
AC
Firmware Update Status
C0
C1
C2
Firmware Download Request Reject
Section 5: Programming
Description of Response
Code
Version check failed
Image type mismatch
Device type mismatch
Hardware type mismatch
General variant mismatch
Firmware header wrong length
System update pending -
panel is armed
System update pending -AC
trouble (Any AC trouble;
device/module)
System update pending -low
battery (Any low battery
trouble; device/module)
System update pending - com-
munication in progress
System firmware update suc-
cessful
System firmware update fail-
ure
System firmware update fail-
ure - module not found
Device firmware transfer begin None
Device firmware module
update begin
General device firmware trans-
fer failure
System ready to update
System update cancel request
received
System update begin
- 148 -
Corresponding Action
Contact DSC Tech Support, described the
action attempted with the system and supply
them with the Response Code in Section
[983].
Disarm the panel to continue with system
firmware update process.
Resolve the AC trouble to continue with sys-
tem firmware update process.
Resolve the low battery trouble to continue
with system firmware update process.
Retry in a few minutes; if issue persists, con-
tact DSC Tech Support.
None
At least one module was not updated. Use
DLS to reapply the firmware to the module
not updated.
At least one module was not responding dur-
ing firmware update. Ensure all modules
enrolled are physically connected and
powered up.
None
Contact DSC Tech Support, describe the
action attempted with the system and supply
them with the Response Code in Section
[983].
None
The system has received an update cancel
request from DLS.
None