Lacp System-Mac; Lacp System-Number - H3C S6550X-HI Series Command Reference Manual

Examples
# Specify port speed as the prioritized criterion for reference port selection on Layer 2 dynamic
aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
[Sysname-Bridge-Aggregation1] lacp select speed

lacp system-mac

Use
lacp system-mac
Use
undo lacp system
Syntax
lacp system-mac mac-address
undo lacp system-mac
Default
The LACP system MAC address is the bridge MAC address of the device.
Views
System view
Predefined user roles
network-admin
Parameters
mac-address
all-zero, all-F, or multicast MAC address.
Usage guidelines
All S-MLAG devices must use the same LACP system MAC address.
LACPDUs carry the LACP system MAC address configured by using this command. To identify the
LACP system MAC address used by a link aggregation group, examine the System ID field in the
output from the
You can configure the LACP system MAC address globally and in aggregate interface view. The
global LACP system MAC address takes effect on all aggregation groups, and an
aggregate-interface-specific LACP system MAC address takes precedence over the global LACP
system MAC address.
Examples
# Set the LACP system MAC address to 0001-0001-0001.
<Sysname> system-view
[Sysname] lacp system-mac 1-1-1
Related commands
display link-aggregation verbose

lacp system-number

Use
lacp system-number
to set the LACP system MAC address.
to restore the default.
: Specifies a MAC address in the format of H-H-H. The MAC address cannot be an
display link-aggregation verbose
to set the LACP system number used by the local device.
command.
21