Leds; System Status Led; Qsfp28 Port Led; Qsfp+ Port Led - H3C S6850 Series Manual

5

LEDs

System status LED

The system status LED shows the operating status of the switch.
Table5-1 System status LED description
LED mark
SYS

QSFP28 port LED

Table5-2 QSFP28 port LED description
LED status
Steady green
Flashing green
Steady yellow
Flashing yellow (3 Hz)
Off

QSFP+ port LED

Each QSFP+ port has a status LED to show its operating status and activities.
Table5-3 QSFP+ port LED description
LED status
Steady green
Status Description
Steady green The switch is operating correctly.
Flashing green The switch is performing power-on self test (POST).
Steady red The system POST has failed or a system failure has occurred.
Some ports failed in POST and do not work.
NOTE:
Flashing red
The system does not perform POST if the BootWare boot mode is fast
mode.
Helps you to locate the switch.
Flashing blue
To locate the switch in the rack, execute the
(3 Hz)
blink-time
Off The switch is powered off or has failed to start up.
Description
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 100 Gbps.
The port is sending or receiving data at 100 Gbps.
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 10 Gbps, 25 Gbps, or 40 Gbps.
The port is sending or receiving data at 10 Gbps, 25 Gbps, or 40 Gbps.
No transceiver module or cable has been installed or no link is present on the port.
Description
A transceiver module or cable has been correctly installed. The port has a link
and is operating at 40 Gbps.
command. The LED then flashes blue at 3 Hz.
5-48
locator blink