Link-Aggregation Switchover - H3C S6550X-HI Series Command Reference Manual

[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum percentage 50
# Set the minimum percentage of Selected ports to 50% for Layer 3 aggregate interface
Route-Aggregation 1.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1] link-aggregation selected-port minimum percentage 50
Related commands
link-aggregation selected-port minimum

link-aggregation switchover

Use
link-aggregation switchover
in a 1+1 backup aggregation group.
Syntax
link-aggregation switchover
Views
Layer 3 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
This command might cause traffic loss. Make sure you are fully aware of the impacts of this
command when you execute it on a live network.
Use this command to switch member port roles for a 1+1 backup aggregation group whose primary
member port is set by the system when the state of peer ports changes.
If the
link-aggregation secondary-down
group, the
link-aggregation switchover
port for it to take over the primary role.
Before you execute the
aggregation group, verify that the following requirements are met:
•
The aggregation group contains one Selected port and one Unselected port.
•
The primary member port is set by the system.
•
The secondary member port can become Selected.
Examples
# Perform a primary/secondary member port switchover in the aggregation group of
Route-Aggregation 1.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1] link-aggregation switchover
This operation will change the current link status. Continue? [Y/N]:
Related commands
link-aggregation mode
to perform a primary/secondary member port switchover
link-aggregation switchover
36
command has been executed for the aggregation
command brings up the down secondary member
command for a 1+1 backup