Jumboframe Enable - H3C S6550X-HI Series Command Reference Manual

Predefined user roles
network-admin
Parameters
interface-number
interface-number
Usage guidelines
When you create a Layer 3 aggregate interface, the system automatically creates a Layer 3
aggregation group with the same number. The Layer 3 aggregation group operates in static
aggregation mode by default.
Deleting a Layer 3 aggregate interface also deletes the Layer 3 aggregation group. At the same time,
the member ports of the aggregation group, if any, leave the aggregation group.
Examples
# Create Layer 3 aggregate interface Route-Aggregation 1 and enter its view.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1]

jumboframe enable

Use
jumboframe enable
Use
undo jumboframe enable
Use
undo jumboframe enable size
Syntax
jumboframe enable [ size ]
undo jumboframe enable [ size ]
Default
An aggregate interface allows jumbo frames with a maximum length of 10304 bytes to pass through.
Views
Layer 2 aggregate interface view
Layer 3 aggregate interface view
Predefined user roles
network-admin
Parameters
: Specifies the maximum length of jumbo frames, in bytes. The value range for this argument is
size
1536 to 10304.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
Examples
# Allow jumbo frames on Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> System-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] jumboframe enable
: Specifies a Layer 3 aggregate interface number. The value range for the
argument is 1 to 1024.
to allow the jumbo frames on an interface to pass through.
to deny jumbo frames on an interface.
to restore the default.
17