Lldp Ignore-Pvid-Inconsistency; Lldp Management-Address - H3C S6550X-HI Series Command Reference Manual

Examples
# Set the TTL multiplier to 6.
<Sysname> system-view
[Sysname] lldp hold-multiplier 6
Related commands
lldp timer tx-interval

lldp ignore-pvid-inconsistency

Use
lldp ignore-pvid-inconsistency
Use
undo lldp ignore-pvid-inconsistency
Syntax
lldp ignore-pvid-inconsistency
undo lldp ignore-pvid-inconsistency
Default
LLDP PVID inconsistency check is enabled.
Views
System view
Default command level
network-admin
Usage guidelines
By default, when the system receives an LLDP packet, it compares the PVID value contained in
packet with the PVID configured on the receiving interface. If the two PVIDs do not match, a log
message will be printed to notify the user.
You can disable PVID inconsistency check if different PVIDs are required on a link.
Examples
# Disable LLDP PVID inconsistency check.
<Sysname> system-view
[Sysname] lldp ignore-pvid-inconsistency

lldp management-address

Use
lldp management-address
receiving an LLDP frame that carries a management address TLV.
Use
undo lldp management-address
Syntax
In Layer 2 Ethernet interface view:
lldp management-address { arp-learning | nd-learning } vlan vlan-id
undo lldp management-address { arp-learning | nd-learning }
In Layer 3 Ethernet interface view:
lldp management-address { arp-learning | nd-learning } [ vlan vlan-id ]
undo lldp management-address { arp-learning | nd-learning }
to disable LLDP PVID inconsistency check.
to enable LLDP PVID inconsistency check.
to enable the device to generate an ARP or ND entry after
to restore the default.
26