Priority-Flow-Control Dot1P Ingress-Buffer Static; Priority-Flow-Control Dot1P Ingress-Threshold-Offset - H3C S6550X-HI Series Command Reference Manual

priority-flow-control no-drop dot1p

priority-flow-control dot1p ingress-buffer static

Use
priority-flow-control dot1p ingress-buffer static
pressure frame triggering threshold.
Use
undo priority-flow-control dot1p ingress-buffer
Syntax
priority-flow-control dot1p dot1p-list ingress-buffer static threshold
undo priority-flow-control dot1p dot1p-list ingress-buffer
Default
The static back pressure frame triggering threshold is not set.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
dot1p : Specifies an 802.1p priority in the range of 0 to 7.
threshold
to 196608.
Usage guidelines
Before executing this command, you must use the
command to enable PFC for the specified 802.1p priority and use the
command to enable PFC on the specified interface.
enable
If you execute this command for the same 802.1p priority multiple times, the most recent
configuration takes effect.
Examples
# Set the static back pressure frame triggering threshold to 1000 for 802.1p priority 1.
<sysname> system-view
[ ]
Sysname
[
Sysname-Twenty-FiveGigE1/0/1
Related commands
priority-flow-control
priority-flow-control
priority-flow-control no-drop dot1p

priority-flow-control dot1p ingress-threshold-offset

Use priority-flow-control dot1p ingress-threshold-offset
between the back pressure frame stopping threshold and triggering threshold.
Use
undo priority-flow-control dot1p ingress-threshold-offset
default.
: Specifies the static back pressure frame triggering threshold. The value range is 128
interface twenty-fivegige 1/0/1
]
(Ethernet interface view)
(System view)
priority-flow-control no-drop dot1p
priority-flow-control dot1p 1 ingress-buffer static 1000
13
to set the static back
to restore the default.
priority-flow-control
to set the offset
to restore the