Unicast-Suppression - H3C S6550X-HI Series Command Reference Manual

Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
: Sets the interface speed to 10 Mbps.
10
: Sets the interface speed to 100 Mbps.
100
: Sets the interface speed to 1000 Mbps.
1000
: Sets the interface speed to 10000 Mbps.
10000
: Sets the interface speed to 25000 Mbps.
25000
: Sets the interface speed to 40000 Mbps.
40000
: Sets the interface speed to 100000 Mbps.
100000
: Enables the interface to negotiate a speed with its peer.
auto
Usage guidelines
For an Ethernet copper port, use the
peer interface. Support of copper ports for keywords of this command varies by copper port type. For
more information, use the
operation failed when you configure a speed for a copper port, the copper port supports this speed.
Otherwise, the copper port does not support this speed.
For a fiber port, use the
Support of fiber ports for keywords of this command varies by fiber port type. For more information,
use the
speed ?
when you configure a speed for a fiber port, the fiber port supports this speed. Otherwise, the fiber
port does not support this speed.
Additionally, you must select a speed for a fiber port according to the transceiver module installed to
ensure that the transceiver module can be used properly. If the transceiver module installed in a fiber
port does not support the speed for the fiber port, the transceiver module cannot be used.
Examples
# Configure Twenty-FiveGigE 1/0/1 to autonegotiate the speed.
<Sysname> system-view
[Sysname] interface twenty-fivegige 1/0/1
[Sysname-Twenty-FiveGigE1/0/1] speed auto

unicast-suppression

Use
unicast-suppression
unicast storm suppression threshold.
Use
undo unicast-suppression
Syntax
unicast-suppression { ratio | pps max-pps | kbps max-kbps }
undo unicast-suppression
Default
Ethernet interfaces do not suppress unknown unicast traffic.
speed
speed ? command in interface view. If the system does not prompt that
command to set its speed to match the rate of a transceiver module.
speed
command in interface view. If the system does not prompt that operation failed
to enable unknown unicast storm suppression and set the unknown
to disable unknown unicast storm suppression.
command to set its speed to match the speed of the
34