Link-Aggregation Mode - H3C S6550X-HI Series Command Reference Manual

Syntax
link-aggregation lacp isolate
undo link-aggregation lacp isolate
Default
Aggregate interfaces are not isolated.
Views
System view
Predefined user roles
network-admin
Usage guidelines
Aggregate interface isolation is applicable to dynamic aggregate interfaces. It gracefully changes all
dynamic interfaces on the device and member ports of the counterpart aggregation groups to the
Unselected state.
This feature takes effect only on dynamic aggregate interfaces. It cannot isolate static aggregate
interfaces.
Examples
# Isolate aggregate interfaces.
<Sysname> system-view
[Sysname] link-aggregation lacp isolate

link-aggregation mode

Use
link-aggregation mode
Use
undo link-aggregation mode
Syntax
link-aggregation mode { dynamic | static [ backup ] }
undo link-aggregation mode
Default
An aggregation group operates in static aggregation mode.
Views
Layer 2 aggregate interface view
Layer 3 aggregate interface view
Predefined user roles
network-admin
Parameters
: Specifies dynamic mode and enables LACP.
dynamic
: Specifies static mode.
static
: Specifies static 1+1 backup mode. If you do not specify this keyword, 1+1 backup is not
backup
enabled. Only Layer 3 aggregate interfaces support this keyword.
to set the aggregation mode of an aggregation group.
to restore the default.
29