Lldp Enable - H3C S6550X-HI Series Command Reference Manual

Management Ethernet interface view
Layer 2 aggregate interface view
Layer 3 aggregate interface view
Predefined user roles
network-admin
Parameters
: Specifies an LLDP agent type. If you do not specify an agent type in Ethernet or
agent
management Ethernet interface view, the command enables LLDP polling and sets the polling
interval for nearest bridge agents.
nearest-customer
nearest-nontpmr
interval
Examples
# Enable LLDP polling and set the polling interval to 30 seconds for the nearest customer bridge
agents on Twenty-FiveGigE 1/0/1.
<Sysname> system-view
[Sysname] interface twenty-fivegige 1/0/1
[Sysname-Twenty-FiveGigE1/0/1] lldp agent nearest-customer check-change-interval 30

lldp enable

Use lldp enable
Use
undo lldp enable
Syntax
lldp enable
undo lldp enable
Default
LLDP is enabled on a port.
Views
Layer 2 Ethernet interface view
Layer 3 Ethernet interface view
Management Ethernet interface view
Layer 2 aggregate interface view
Layer 3 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
LLDP takes effect on a port only when LLDP is enabled both globally and on the port.
Examples
# Disable LLDP on Twenty-FiveGigE 1/0/1.
<Sysname> system-view
: Specifies nearest customer bridge agents.
: Specifies nearest non-TPMR bridge agents.
: Sets the LLDP polling interval in the range of 1 to 30 seconds.
to enable LLDP on a port.
to disable LLDP on a port.
21