Tftp Client Source - H3C S6550X-HI Series Command Reference Manual

Examples
# Specify the source IPv6 address of 2000::1 for TFTP packets sent to an IPv6 TFTP server.
<Sysname> system–view
[Sysname] tftp client ipv6 source ipv6 2000::1
Related commands
tftp ipv6

tftp client source

Use
tftp client source
TFTP server.
Use
undo tftp client source
Syntax
tftp client source { interface interface-type interface-number | ip
source-ip-address }
undo tftp client source
Default
No source IPv4 address is specified for TFTP packets sent to an IPv4 TFTP server. The device uses
the primary IPv4 address of the output interface for the route to the server as the source address.
Views
System view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number
number. The device will use the interface's primary IPv4 address as the source address. For
successful TFTP packet transmission, make sure the interface is up and has the primary IPv4
address configured.
ip source-ip-address
make sure this address is the IPv4 address of an interface in up state on the device.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
The source address specified with the
specified with the
The source address specified with the
connections. The source address specified with the
connection that is being established.
Examples
# Specify the source IP address of 192.168.20.222 for TFTP packets sent to an IPv4 TFTP server.
<Sysname> system-view
[Sysname] tftp client source ip 192.168.20.222
Related commands
tftp
to specify the source IPv4 address for TFTP packets sent to an IPv4
to restore the default.
: Specifies an IPv4 address. For successful TFTP packet transmission,
tftp
tftp client source
: Specifies an interface by its type and
command takes precedence over the source address
command.
tftp client source
command applies only to the TFTP
tftp
42
command applies to all TFTP