Port Lacp System-Priority - H3C S6550X-HI Series Command Reference Manual

Parameters
mac-address
all-zero, all-F, or multicast MAC address.
Usage guidelines
LACPDUs carry the LACP system MAC address configured by using this command. To identify the
LACP system MAC address used by a link aggregation group, examine the System ID field in the
output from the
You can configure the LACP system MAC address globally and in aggregate interface view. The
global LACP system MAC address takes effect on all aggregation groups, and an
aggregate-interface-specific LACP system MAC address takes precedence over the global LACP
system MAC address.
Member devices in an S-MLAG system must use the same LACP system MAC address.
Examples
# Set the LACP system MAC address to 0002-0002-0002 on Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port lacp system-mac 2-2-2
Related commands
display link-aggregation verbose
lacp system-mac

port lacp system-priority

Use
port lacp system-priority
Use
undo port lacp system-priority
Syntax
port lacp system-priority priority
undo port lacp system-priority
Default
The LACP system priority is 32768.
Views
Layer 2 aggregate interface view
Layer 3 aggregate interface view
Predefined user roles
network-admin
Parameters
priority : Specifies the LACP system priority in the range of 0 to 65535. The smaller the value, the
higher the LACP system priority.
Usage guidelines
LACPDUs carry the LACP system priority configured by using this command. To identify the LACP
system priority used by a link aggregation group, examine the System ID field in the output from the
display link-aggregation verbose
: Specifies a MAC address in the format of H-H-H. The MAC address cannot be an
display link-aggregation verbose
command.
to set the LACP system priority on an aggregate interface.
to restore the default.
command.
38