Reset Ethernet Statistics; Reset Link-State-Change Statistics Interface - H3C S6550X-HI Series Command Reference Manual

Ethernet interfaces can operate either as Layer 2 or Layer 3 Ethernet interfaces. You can use this
command to set the link mode to bridge (Layer 2) or route (Layer 3) for these Ethernet interfaces.
Examples
# Configure Twenty-FiveGigE 1/0/1 to operate in Layer 2 mode.
<Sysname> system-view
[Sysname] interface twenty-fivegige 1/0/1
[Sysname-Twenty-FiveGigE1/0/1] port link-mode bridge

reset ethernet statistics

Use
reset ethernet statistics
Syntax
reset ethernet statistics [ slot slot-number ]
Views
User view
Predefined user roles
network-admin
Parameters
slot slot-number
Examples
# Clear the Ethernet module statistics for the specified slot.
<Sysname> reset ethernet statistics slot 1
Related commands
display ethernet statistics

reset link-state-change statistics interface

Use
reset link-state-change statistics interface
statistics of interfaces.
Syntax
reset link-state-change
[ interface-number ] ]
Default
Link state change statistics of an interface are not cleared.
Views
User view
Predefined user roles
network-admin
Parameters
interface-type
interface-number
to clear the Ethernet module statistics.
: Specifies the slot number of the device, which is fixed at 1.
statistics
: Specifies an interface type.
: Specifies an interface number.
interface
32
to clear link state change
[ interface-type