Link-Aggregation Port-Priority - H3C S6550X-HI Series Command Reference Manual

Usage guidelines
When you change the aggregation mode, make sure you understand the impact of the change on
services.
Aggregation mode change might cause Selected member ports to become Unselected.
The following restrictions apply to an aggregation group operating in 1+1 backup mode:
•
The aggregation group can contain a maximum of two member ports.
•
The maximum and minimum limits on the number of Selected ports in the aggregation group do
not take effect.
Examples
# Configure Layer 2 aggregation group 1 to operate in dynamic aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic

link-aggregation port-priority

Use link-aggregation port-priority
Use
undo link-aggregation port-priority
Syntax
link-aggregation port-priority priority
undo link-aggregation port-priority
Default
The port priority of an interface is 32768.
Views
Layer 2 Ethernet interface view
Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
: Specifies the port priority in the range of 0 to 65535. The smaller the value, the higher
priority
the port priority.
Examples
# Set the port priority to 64 for Layer 2 Ethernet interface Twenty-FiveGigE 1/0/1.
<Sysname> system-view
[Sysname] interface twenty-fivegige 1/0/1
[Sysname-Twenty-FiveGigE1/0/1] link-aggregation port-priority 64
# Set the port priority to 64 for Layer 3 Ethernet interface Twenty-FiveGigE 1/0/2.
<Sysname> system-view
[Sysname] interface twenty-fivegige 1/0/2
[Sysname-Twenty-FiveGigE1/0/2] link-aggregation port-priority 64
Related commands
lacp system-priority
to set the port priority of an interface.
to restore the default.
30