For this command to take effect on an aggregation group, first configure the aggregation group to
operate in 1+1 backup mode.
Examples
# Configure Route-Aggregation 1 to place its secondary member port in down state.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1] link-aggregation secondary-down
Related commands
link-aggregation mode
link-aggregation selected-port maximum
Use
link-aggregation selected-port maximum
ports allowed in an aggregation group.
Use
undo link-aggregation selected-port maximum
Syntax
link-aggregation selected-port maximum max-number [ lacp-sync ]
undo link-aggregation selected-port maximum
Default
The maximum number of Selected ports allowed in an aggregation group is 8.
Views
Layer 2 aggregate interface view
Layer 3 aggregate interface view
Predefined user roles
network-admin
Parameters
max-number
The value range for this argument is 1 to 256.
lacp-sync
specify this keyword, the aggregate interface does not synchronize the maximum number of
Selected ports with the peer.
Usage guidelines
Executing this command might cause some of the Selected ports in an aggregation group to become
Unselected ports.
On a static aggregate link, you must set the maximum number of Selected ports to the same value at
its two ends.
On a dynamic aggregate link, you must set the maximum number of Selected ports to the same
value at its two ends if you do not specify the
two ends of the aggregate link compare their maximum Selected port number settings and use the
smaller value.
For an aggregation group, the maximum number of Selected ports must be equal to or higher than
the minimum number of Selected ports.
The maximum number of Selected ports allowed in an aggregation group is limited by one of the
following values, whichever value is smaller:
: Specifies the maximum number of Selected ports allowed in an aggregation group.
: Synchronizes the maximum number of Selected ports through LACPDUs. If you do not
to set the maximum number of Selected
keyword. If you specify this keyword, the
lacp-sync
33
to restore the default.