Lldp Source-Mac Vlan - H3C S6550X-HI Series Command Reference Manual

Default
LLDP trapping is disabled.
Views
Layer 2 Ethernet interface view
Layer 3 Ethernet interface view
Management Ethernet interface view
Layer 2 aggregate interface view
Layer 3 aggregate interface view
Predefined user roles
network-admin
Parameters
: Specifies an LLDP agent type. If you do not specify an agent type in Ethernet or
agent
management Ethernet interface view, the command enables LLDP trapping for nearest bridge
agents.
nearest-customer
nearest-nontpmr
Examples
# Enable LLDP trapping for the nearest customer bridge agent on Twenty-FiveGigE 1/0/1.
<Sysname> system-view
[Sysname] interface Twenty-FiveGigE 1/0/1
[Sysname-Twenty-FiveGigE1/0/1] lldp agent nearest-customer notification remote-change
enable

lldp source-mac vlan

Use
lldp source-mac vlan
MAC address of a VLAN interface or a Layer 3 Ethernet/aggregate interface.
Use
undo lldp source-mac vlan
Syntax
lldp source-mac vlan vlan-id
undo lldp source-mac vlan
Default
The source MAC address of LLDP frames is the MAC address of the egress Layer 2 Ethernet
interface, Layer 3 Ethernet interface, or Layer 3 aggregate interface.
Views
Layer 2 Ethernet interface view
Layer 3 Ethernet interface view
Layer 3 aggregate interface view
Default command level
network-admin
: Specifies nearest customer bridge agents.
: Specifies nearest non-TPMR bridge agents.
to set the source MAC address of outgoing LLDP frames to the
to restore the default.
35