Static-Bind - H3C S6550X-HI Series Command Reference Manual

Predefined user roles
network-admin
Parameters
address-exhaust
pool.
allocated-ip
The threshold is set by the
ip-in-use
The threshold is set by the
Usage guidelines
If you do not specify any parameters, this command enables SNMP notifications for all types of
DHCP server events.
To report critical DHCP server events to an NMS, enable SNMP notifications for the DHCP server.
For DHCP server event notifications to be sent correctly, you must also configure SNMP on the
device. For more information about SNMP configuration, see the network management and
monitoring configuration guide for the device.
Examples
# Enable SNMP notifications for all types of DHCP server events.
<Sysname> system-view
[Sysname] snmp-agent trap enable dhcp server
# Enable SNMP notifications for DHCP address pool exhaustion or recovery.
<Sysname> system-view
[Sysname] snmp-agent trap enable dhcp server address-exhaust
# Enable SNMP notifications for IP address allocation success rate threshold violation.
<Sysname> system-view
[Sysname] snmp-agent trap enable dhcp server allocated-ip
# Enable SNMP notifications for DHCP address pool usage threshold violation.
<Sysname> system-view
[Sysname] snmp-agent trap enable dhcp server ip-in-use
Related commands
dhcp server allocated-ip threshold
ip-in-use threshold
snmp-agent target-host

static-bind

Use
static-bind
Use
undo static-bind
Syntax
static-bind
{ client-identifier
hardware-address [ ethernet | token-ring ] }
undo static-bind ip-address ip-address
: Specifies notifications about the exhaustion or recovery of a DHCP address
: Specifies notifications about IP address allocation success rate threshold violation.
dhcp server allocated-ip threshold
: Specifies notifications about the usage threshold violation in a DHCP address pool.
ip-in-use threshold
(Network Management and Monitoring Command Reference)
to statically bind a client ID or MAC address to an IP address.
to remove a static binding.
ip-address
command.
ip-address [ mask-length
client-identifier
54
command.
| mask mask
| hardware-address
]