Assembly Replacement Procedures
Disk Drive
5. Remove the disk drive (2) from the carrier assembly.
6. Place the new disk drive onto the carrier assembly and attach with the 4
7. Refer to
8. Locate the Windows License Sticker from the kit and apply the sticker to
Figure 16-82
Windows License Sticker Rear Panel Location
9. Refer to
504
machine screws (1) (0515-0372). Torque to 9 in-pounds.
Figure
16-80. Replace the disk drive carrier assembly (2) into the
instrument and tighten the screw to 9 in-pounds.
the rear of the instrument as shown in
license sticker.
Chapter 17, "Post-Repair Procedures."
specified tasks for replacing the A5 Disk Drive assembly.
Figure
16-82, covering the existing
and perform all of the
N9030A PXA Signal Analyzer Service Guide