Table of Contents
Advertisement
Assembly Replacement Procedures
RF Area (Options 503, 508, 513, 526)
9. Refer to
Figure 16-34
Switch Assembly Installation
454
Figure
16-34. Install the switch assembly (1). Route the switch
control cable between the switch and the chassis. The cable routes over
the LO Synthesizer board ear then plugs into J802. If this is not routed
correctly the cable can be damaged when the top brace is installed. Refer
to
Figure 16-35
and
Figure 16-36
ribbon cable to the Front End Controller J802 as shown. Secure switch
bracket to chassis frame with the two top screws (2) (0515-1035). Secure
switch bracket to the other switch bracket with the single side screw (3)
(0515-0372). Torque screws to 9 inch-lbs.
for cable routing pictures. Connect the
N9030A PXA Signal Analyzer Service Guide
Advertisement
Table of Contents
Troubleshooting
