Setting The Ip Address - Stratasys Fortus 360mc User Manual

Setting the IP Address

1.
Power up the system, see
2.
From the Ready screen, select
3.
Select
4.
Select
5.
Choose
6.
If the
then:
• Select
• Select
• Select
Note: See your system administrator if you do not know the
IP, Netmask, or Gateway address.
7.
Choose
Build Job..
Operator Control..
Modeler Status..
>Maintenance..
Administration
Modeler Default..
>Administration..
Reboot system..
Network Configuration
>Network Configuration..
Receive Software Upgrade or Code..<E>
Field Service.. password:
or for the
YES NO
Dynamic IP: YES <E>
UpnP: ON <E>
*Configure Static Network Address
Dynamic IP: NO <E>
UpnP: ON <E>
>Configure Static Network Address
is set to
Dynamic IP
and enter the address using the keypad. Press ENTER. You can
IP
use the DEL key to erase incorrect entries.
(Netmask) and enter the address. Press ENTER.
MASK
(Gateway) and enter the address. Press ENTER.
GW
>IP : [172.16.70.10]
MASK: (.none found)
GW : [172.16.100.1]
or for the
YES NO
"Powering Up the System" on page
and press ENTER.
Maintenance
| *Tips: Model T16
| * Support T16
and press ENTER.
and press ENTER.
Dynamic IP
, select
NO Configure Static Network Address
UPnP
2-4
4-3.
,