HPE ProLiant DL380 Gen11 User Manual page 144

Installing tertiary risers Installing tertiary risers
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-10 Torx screwdriver
A tertiary riser cage is required to install this option.
Procedure Procedure
1. Power down the server.
2. Do one of the following:
Disconnect each power cord from the power source.
Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the riser cage.
6. Install the riser.
7. If needed, install an expansion board .
8. If needed, connect data cables to the riser or expansion board.
9. Install the tertiary riser cage:
HPE ProLiant DL380 Gen11 Server User Guide 144