HPE ProLiant DL380 Gen11 User Manual page 101

Before beginning installation, make sure that the server is updated with the latest operating system firmware and drivers.
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
Note the following:
The HPE NS204i-u Gen11 NVMe Hot Plug Boot Optimized Storage Device is a PCIe3 x4 custom form-factor module that includes two
hot pluggable 2280 M.2 NVMe SSDs.
HPE NS204i-u Boot Device auto-creates a RAID1 volume during boot, therefore does not require configuration.
Identify the HPE NS204i Boot Device components.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Install the drives to the boot device.
6. Install the boot device to the mounting bracket.
7. To allow drive access, remove the security cover.
If you want to secure drive access, keep the security cover installed.
HPE ProLiant DL380 Gen11 Server User Guide 101