HPE ProLiant DL380 Gen11 User Manual page 82

12. Install the access panel .
13. Slide the server into the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server .
Results Results
The installation is complete.
Installing a rear serial port interface Installing a rear serial port interface
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the serial port blank.
6. Install the serial port interface.
HPE ProLiant DL380 Gen11 Server User Guide 82